Solar LED street lights are lights made of a crystalline silicon PV panel (power supply), smart controller, lithium or lead-acid battery (stock power), higher LED source and other components. A special PIR sensor can provide smart control capabilities or multi-function extension.

LED lights are 30-50% more efficient than most traditional street lights.

The all-in-one solar street light features an efficient mono PV panel, long lifespan LiFePO4 lithium battery, brighter brand LED, smart controller and PIR sensor in one cabinet. The AE3C Series is easy to install — it takes two workers only five minutes to finish installation.

1. Car lane: average illumination, illumination uniformity and lengthways uniformity, glare limit, surround ratio and inductivity
2. Sidewalk: average illumination, mix illumination and vertical illumination

PV Panels are made of a semiconductor material like silicon, along with phosphorous and boron which create conductivity within the cell and activate the movement of electrons. When activated by the sunlight’s energy, the electrons move across the cell and into the electrical circuit attached to the solar panel.

Shading a photovoltaic system dramatically decreases its output. Just shading the bottom row of wafers alone amounts to an 80% reduction in efficiency.

LEDs are light-emitting diodes, or electronic components that produce light by converting electrical energy directly to light by the movement of electrons within the material of the diode. Because LEDs are highly efficient, they are beginning to replace most conventional light sources.

The term solid-state lighting is used because the electronics produce light directly from solid materials in which the electrons are embedded. This is unlike other technologies; for example, fluorescent technology requires a gaseous discharge medium to initiate production of light.

The term solid-state lighting is used because the electronics produce light directly from solid materials in which the electrons are embedded. This is unlike other technologies; for example, fluorescent technology requires a gaseous discharge medium to initiate production of light.

The term solid-state lighting is used because the electronics produce light directly from solid materials in which the electrons are embedded. This is unlike other technologies; for example, fluorescent technology requires a gaseous discharge medium to initiate production of light.

LEDs have no gases, filaments or other moving parts. They provide light through a one-step process that takes place within the diode. You don’t have to worry about broken glass or other parts breaking or coming loose.

LEDs have no gases, filaments or other moving parts. They provide light through a one-step process that takes place within the diode. You don’t have to worry about broken glass or other parts breaking or coming loose.

Controllers are very important for solar street lights because they can remotely turn lights on or off. Our Leadsun controllers are programmable so the user can decide the appropriate amounts of charging, lighting and dimming.

The only way to get full power out of high voltage grid tie solar panels is to use an MPPT controller. Since most MPPT controls can take up to 150 volts DC (some can go up to 600 VDC) on the solar panel input side, you can often series two or more of the high voltage panels to reduce wire losses or use smaller wires. With the 175-watt panel mentioned above, putting two of them in a series would give you 66 volts at 7.6 amps into the MPPT controller, but the controller would convert that to about 29 amps at 12 volts.

A lithium-ion battery is a rechargeable battery in which lithium ions move from the negative electrode to the positive electrode during discharge and back when charging.

Normally ten to twelve years. If you are using double batteries interactively, as we do in our Leadsun lights, you can expect the batteries to last much longer say fifteen even twenty years.

For solar lights, Battery Autonomy is the number of nights the light will keep shining from a full battery if there is no solar charge.
Our Leadsun batteries have a battery autonomy of 4 nights providing safe and sustainable lighting even on the cloudiest of foggy days!

In our Leadsun opinion;
- IP66 water jet and dust ingress rated.
- IK08 impact resistant.
- Some demanding authority standards such as the Australian Lighting Council, ITL (Israel test Laboratory authority), Abu Dhabi Public Lighting Manual.
- IDA (Dark Sky Ascociation) approved.